Home > Contact & Support > Support Information for JVC Audio Products > Blu-ray Network Media System NX-BD3 Updater > Firmware update for NX-BD3

Firmware update for NX-BD3

Blu-ray Network Media System NX-BD3 Updater

NX-BD3 Firmware Ver.1015
Released on: April 16 2010

File description

This file is for JVC Blu-ray Theater System NX-BD3 firmware Ver.1015.
* Exclusively for NX-BD3. Do not use for other models as it may cause malfunction.

For download, please enable 'JavaScript' on your web browser.


Improvement

Ver.1015
  • Playability and Stability. (Apr. 16 2010)
Ver.1014
  • Playability and Stability. (Jul. 23 2009)
Ver.1013
  • Playability and Stability. (May 12 2009)
Ver.1012
  • Playability and Stability. (Mar. 2 2009)


Precautions before update

Check the firmware version currently installed in your system before downloading.

  1. Turn on the main unit.
  2. Press [DISC] button.
  3. Press and hold [ || ] button approximately 10 seconds before the disc is inserted.
  4. The current firmware version in your system will be displayed on the screen.
  5. If the version is 1015 or higher than 1015, no update is necessary. If the version is lower than 1015, updating is recommended. After checking the version, press [enter] button on the remote control. Continue to next step.

Update procedures

Read the software agreement carefully and download the file only if you agree with the contents.
Download the latest version of the JVCFRMUP.ZIP firmware and save it to your PC Desktop.
Open the Downloaded zip. File. Read attached text file of License-J_E.text before firmup data writing.


Check the file size of the downloaded file

Right click on the downloaded firmware, "JVCFRMUP.U01" and select "Properties". Make sure that the size of the file is 116,393,984 bytes.


Create a firmware update disc

Write "JVCFRMUP.U01" to a CD-R disc using CD-R writing software. Follow the operating instructions for the writing software to create the disc.

  • Use a blank CD-R disc.
  • Do not use a CD-RW disc.
  • Packet-writing is not supported.
  • UDF format is not supported.

Update of main unit

  1. Turn on the main unit.
  2. Press [DISC] button.
  3. Insert the firmware update disc.
  4. "Start updating. Do not turn off power during the update. [OK]" will be displayed on the screen. Press [ENTER] button on the remote control.
  5. It will take approximately 4 minutes to update the firmware. Do not turn off the main unit, disconnect AC power, nor press any buttons during updating.
  6. About 4 minutes later the disc tray will be opened automatically.
  7. Remove the firmware update disc and press [POWER] button.

File download

Read the software agreement carefully and download the file only if you agree with the contents.


Download of Software for Blu-ray Theater System

Important:

This End-User License Agreement ("Agreement") is regarding the software ("Software") to update the firmware of the Blu-ray Theater System, Model No. NX-BD3 ("Product"). Please carefully read this Agreement before downloading the Software. The right to download and use the Software is granted by JVCKENWOOD Corporation ("JKC") to end-user ("You") only on the condition that You agree to the following Agreement. If You do not agree to the terms of the Agreement, you may not download or use the Software any more. HOWEVER, DOWNLOADING THE SOFTWARE SHALL BE DEEMED AS YOUR ACCEPTANCE OF TERMS AND CONDITIONS OF THIS AGREEMENT.




For download, please agree to the 'END-USER LICENSE AGREEMENT' by checking the below check box and click DOWNLOAD.

DOWNLOAD

JVCFRMUP.ZIP



[issued:Apr.16,2010]