Home > Contact & Support > Support Information for JVC Audio Products > Micro component system UX-VJ5/UX-VJ3 Updater

Micro component system UX-VJ5/UX-VJ3 Updater

Micro component system UX-VJ5/UX-VJ3 Updater

UX-VJ5/UX-VJ3 Firmware Ver. 53
Released on: January 15 2013

File description

This file is for JVC Micro component system UX-VJ5/UX-VJ3 firmware Ver. 53.
NOTICE:
UX-VJ3 USA and a Canadian models are excluded. Please ask a service center about update.


For download, please enable 'JavaScript' on your web browser.


Improvement

Ver. 53
  • It becomes impossible to charge with iPad when Update is done to iOS6. (January 15 2013)


Update procedures

This update is performed via USB thumb drive


Creating the Firmware Update Device

Read the software agreement carefully and download the file only if you agree with the contents.

<Correspondence>
Updating firmware to Ver.53 or more by USB thumb drive.

(1) Download the latest version of the firmware and save it to your PC Desktop.
image

(2) Insert a USB thumb drive into your PC.
Note: This USB thumb drive must be formatted to FAT16 or FAT32 and must have at least 50MB of free space.

(3) Open the Downloaded zip file. Copy the file "UXVJ3_5_.hex" from the zip folder.

(4) Paste the file"UXVJ3_5_.hex" to USB Drive folder.
* Please use USB without other files and folders.
image

(5) Remove the USB thumb drive from the PC, it is now ready to update the UX-VJ3/UX-VJ5.


Updating Firmware

(6) Turn on the power supply switch.

(7) Choose the USB source. Displayed as "NO USB".
image

(8) Insert USB thumb drive in a USB port on the top panel of the UX-VJ3 or UX-VJ5.
image

(9) When USB is applied, it is displayed as "UPGRADE".
image

(10) Please push "SET" of remote control. Displayed as "MCU FIRM".
image

(11) System reset will lie in about one minute, and the display disappears.

<Confirmation of update>
"STOP" key and "RESUME" key of Remote Control are pushed at the same time with the power ON mode.
image

In addition, "POWER" key is pushed two times while these buttons are being pushed.
Below information will be displayed.
Model nameMCU versionCD version →,,,,,,
If the display of mcu version is "S A19V53", it is OK.
image

<Attention when updating>
Do not pull out the power strip when you have updated it.
Do not operate the commodity.


File download

Read the software agreement carefully and download the file only if you agree with the contents.


Download of Software for Micro component system

Important:

This End-User License Agreement ("Agreement") is regard to the update to the firmware of the micro component system, Model No. UX-VJ3/UX-VJ5 ("Product") ("Software"). Please carefully read this Agreement before downloading the Software. The right to use the Software is granted by JVCKENWOOD Corporation ("JKC") to You only on the condition that You agree to the following Agreement. If You do not agree to the terms of the Agreement, you may not use the Software any more. HOWEVER, DOWNLOADING THE SOFTWARE INDICATES YOUR ACCEPTANCE OF THESE TERMS AND CONDITIONS.




For download, please agree to the 'END-USER LICENSE AGREEMENT' by checking the below check box and click DOWNLOAD.

DOWNLOAD

UXVJ3_5_v53_USB_update_firmware.zip



[issued:Jan.15,2013]